Saltar al contenido principal

Configuración y gestión de protección

Available commands

Para obtener una lista de todos los comandos disponibles de AdGuard, ingresa:

adguard-cli --help-all

Habilitando y deshabilitando la protección

Enable protection

Para habilitar la protección, ingresa:

adguard-cli start

This command attempts to configure a redirection to the proxy.

Start protection *border

Disable protection

Para deshabilitar la protección, ingresa:

adguard-cli stop

This command not only stops the proxy but also stops the trafic from redirecting to it.

Check protection status

Para ver el estado de la protección, ingresa:

adguard-cli status

Status/Stop protection *border

Updates

Buscar actualizaciones

Para buscar actualizaciones, ingresa:

adguard-cli check-update

Update AdGuard for Linux

Para actualizar AdGuard para Linux, ingresa:

adguard-cli update

Update script output

Para ver la salida del script de actualización, ingresa:

adguard-cli update -v

Configurando o AdGuard para Linux

Usa el comando config para configurar AdGuard para Linux. Subcomandos:

  • show: Muestra la configuración actual en proxy.yaml

    Current setup *border

  • set: Configurar una opción en proxy.yaml

    • listen_ports.http_proxy: puerto HTTP de escucha
    • proxy_mode: Modo proxy (manual u auto)
  • get: Obtener el estado actual de las opciones anteriores

Administrar filtros

Usa el comando filters para configurar AdGuard para Linux. Subcomandos:

  • list: Listar filtros instalados

    • --all: Ver todos los filtrados

      Filter list *border

  • install: Instalar un filtro. Ingrese la URL del filtrado que deseas instalar

  • enable: Habilitar un filtro. Introduce el nombre o ID del filtro

    Enable filters *border

  • disable: Deshabilitar un filtro. Introduce el nombre o ID del filtro

  • update: Actualiza los filtros

Changing the proxy server listen address in manual proxy mode

By default, the proxy server listens on 127.0.0.1 — the address of the loopback network interface. There are two ways to make the proxy server listen on a different interface:

  1. Run adguard-cli config set listen_address <address> where <address> is the address to listen on.
  2. Edit the config file directly:
    • To determine the location of the config file, run adguard-cli config show | grep "Config location".
    • Look for the listen_address key and set its value accordingly. To listen on all available network interfaces, set the listen address to 0.0.0.0 or ::.

If the listen address is set to anything other than 127.0.0.1, then proxy client authentication is required. AdGuard CLI will not start unless proxy authentication is configured:

  • When running adguard-cli config set listen_address <address> where <address> is not 127.0.0.1, AdGuard CLI will prompt for a username and password if proxy authentication is not already configured.
  • When editing the config file directly, look for the listen_authkey. Set the enabled sub-key to true, and username and password to non-empty values.